Interested to Buy Any Domain ? << Click Here >> for more details...
why CT ratio stand for 50/5, 100/5, 25/5.
- 11 Answers
- 68805 Views
- ABB, Ramky, I also Faced
- E-Mail Answers
Answer Posted / jagadish
CTs are Instrument Transformers used for Metering or
sensing where the whole primary current cannot be fed into
meter or relay.Hence the same is porportionately reduced by
ratio and connected to load eg.Ammeter,kwH meter &Relay etc
| Is This Answer Correct ? | 27 Yes | 3 No |
Post New Answer View All Answers
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what is Fault level? why it is calculated? how will u decide same for our plant?
How energy is generated in hydroelectric power plant?
Why Neutral Isolation is required?
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
what is meant by impedance & transient protection?
What is the Current equation in series RLC circuits.
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
