Answer Posted / jakeer

Various reasons for motor getting over heated.
1.Due to faulty bearings.
2.Due to low voltages.
3.Due to load fluctation from the drive end.
4.Due to mis assembly of motor.
5.Due to rotor fotness problem.

Where is the best place to mount  distribution panel in a house.

2066

---

Define relative stability.

1041

---

What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating

1522

---

All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?

1646

---

1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor

4841

---

HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory

1875

---

Fantio of tranformer

2206

---

What is an alternator impedance value?

2839

---

What is the difference between solid grounding and impedance grounding?

2083

---

what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker

5386

---

Describe the test procedure to determine the vector group

2129

---

How much load can take a 16 mm aluminum cable 3 phase

1731

---

Terminal blocks is used for segregate the connections... There is any principle for terminal block..?

2097

---

what is the difference between delta delta and star delta connection transformer? why we use delta delta transformer since it need earthing transformer for grounding?

2073

---

1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?

2310

---