Answer Posted / rajdeepghosh8
the ist answer is correct but it is applicable only when
the two supports are in the same level.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is difference between start imitation and start interlock for 3 phase motor protection ?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What is DC series motor?
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
what is the effect of back reactive power on the generator ?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
When we use 3 terminal resistor?
What are the basic elements used for modeling mechanical translational system?
What is accuracy of a measurement?
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?