Why LVDT have secondary windings connected in differential
1. Higher out put
2. Based on the out put voltage-/+, helps to identify the
direction of displacement
3. To establish a null/ reference point
- 1 Answers
- 5256 Views
- GATE, PSPCL, I also Faced
- E-Mail Answers
Answer Posted / sandeep
the answer is 2&3?. in one of the book i found choice 1..
..Please justify
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
what is negative and zero impedance in 3 phase induction motor ??
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Define closed loop control system.
What is pole of the system?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
what happened when we supply a dc current in dc motor?? can it worked properly?
How to calculate Voltage regulation of 22 KV Over head Line.
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
What are the main advantages of generalized error co-efficients?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
How much ph is maintained of water resistance starter for slipring induction motor ?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
