Interested to Buy Any Domain ? << Click Here >> for more details...
Is that Speed Probe and Vibration Probe sensors are same,if
yes what is the diff b/w them?
- 2 Answers
- 7908 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajith294
normally we are measuring vibration signals are amplitude,
frequecy and phase.
for this we are using the same probe.
vibration is measured as peak to peak, a measure of the
total excursion of the rotor or machine casing in 'mils or
micrometers'.
Frequency is measure of how fast a body is vibrating and is
used to identify the source of vibrations. frequency is
expressed in shaft rotative speed.
for calibrating or checking probe or transmitter using for frequency (rotation / min )
1. adjust gap voltage at zero (-10V)at TK 3
2. put some small sticker on wobbulating part.
3. increase the speed of wobulator (TK3)
3. your out put is measured from multi meter at HZ range
thanks
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
use of split range ? where it is used ? in which control loop it is used ?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
what is the working principal of pribe
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
Positioner usage.
What is the Working principle of Dozing valve?
What is Erosion in a control valve?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Capacitance, resistance ( colour coding ), parallel & series circuits.
How earthing can be checked????
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
