what is flow and flowrate?
definate and diffrentiate it?
pls post a valid ans
thanks in advance
Answer Posted / anup
Flow indicates the quantity (mass or volume) of fluid
passing through a particular vessel or pipe regardless of
the time whereas flowrate indicates the flow with respect
to time.
Is This Answer Correct ? | 24 Yes | 2 No |
Post New Answer View All Answers
which type of filter gives the constant phase characteristics?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
How to convert Differential pressure to flow in TPH
What is difference between Ionization heat and bimetallic heat
Manipulation of dead wt. tester double piston type.
why using negative supply for bentley nevada vibration system ?
What do you know about gail?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Explain Gas Turbine startup and shutdown sequences
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?