How can transformer winding insulation be measured (Delta &
Star Connections)?
Answer Posted / b soni
we can measured by the Wector group it is star or delta
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Tell me all plants load factors i.e which plant operating on which load?
orifice sizing how done, checking & selection
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
For high frequency application we use which transformer?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
what is the ground fault relay,which purpose it will be use,clearly tell me plz
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
How to test Alternator stability test for REF relay
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What is the difference between voltages or potential difference? And what are they?
3phase motor can be used as a Prime mover for alternator.
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.