what happens if we are having very very high cavity and
flashing in a control valve..??? is it stops
working...immediately... or eroded...slowly
Answer Posted / gk3000
Valve does not stop immediately, but of course, due to
cavity / flashing, there will be a great impact on the
valve body. This case, you need to consider some solution
to lessen this phenomena. One may be putting a restriction
on valve inlet, or changing the trim construction of the
valve, or using a high grade material.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
List three types Level Switches with their working principles
what is RTV function in in process control?
what is performance test.need defination
what is diffrance between FF & SMART, explain with difination
What is the constant voltage unit?
what is basic difference between motion balance and force balance in pneumatic instrument?
What is the PLC configuration in Cement industry?
How to calibration coriolis flow meter?
How u measure the massflow in orifice flow measurement techniques
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is the purpose of the analyzer in petrochemical plant?
use of split range ? where it is used ? in which control loop it is used ?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Explain plc level and its type?