Answer Posted / jatinder kumar

thanks mr varun .i was also saying the same. these days i mlooking for a job.i have diploma in electrical engg with 65 % marks from punjab board. i m requested every one pls help me .i will do any job which should related with my trade.if u have any job pls inform me at jatinder_kumar100@yahoo.com
Thanks

i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.

1867

---

detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron

3113

---

what is metering cum synchronizing panel and how it is used?

4617

---

Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.

1573

---

Dear all, how we select the cable size according  to current with or without including different correction factor , is there any direct method for sizing of cable... 

2145

---

Grid fault level [KA]?

2590

---

How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?

1780

---

On what cycle does thermal power plant operate?

1139

---

from which formula we select a capacitor rating?

2092

---

how the inner and outer body is separated in aircrafts?

1075

---

internally connection of photvoltic module

1908

---

A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N

2945

---

Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?

1952

---

how to calculate the settings for shaft ct protn in hydro generators

1951

---

Explain Energy and Power signals?

1747

---