how to choose the cable size for 100A(is there any formula
please update)
- 6 Answers
- 12399 Views
- I also Faced
- E-Mail Answers
Answer Posted / hari
Cable size should be 25 Sq.mm
For Ex: 1000A MCCB
For Al - We have to Consider 0.8/Sq.mm
For Cu - We have to Consider 1.6/Sq.mm
For 1000A = 1000*0.8
= 800A
We have to go for (100X10)mm Bus Bar
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
why constant voltage transformer should be start without load? and if started then what will happen?
what is the basic need of domestic loads 1- voltage 2- current
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
How to design pavement quality concrete by using C.R.C.P Method
what is physical distance of isolator to VCB in 33/11kv sub stations
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
How to find out damper winding failure for synchronous machine?
what is 3rd Harmonics? how it is generated in alternator
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
orifice sizing how done, checking & selection
please send me latest & previous years question papers for IOCL Technical level questions
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
What is zero of the system?
