Interested to Buy Any Domain ? << Click Here >> for more details...
if u have to give support in 1 km long bridge,where u will
give it & how many?
- 10 Answers
- 15844 Views
- HAL, ISRO, I also Faced
- E-Mail Answers
Answer Posted / praveen
the condition is obviously of simply supported beam (we may neglect the point loads in form of vehicles for making our calculations simple)....next thing is we need to check the deflection (which will be max at centre) and shear force(we can get shear stress from calculation) and depending upon the allowable deflection n stress(shear)we will put supports one by one...it is general observation that for 1km u need around 20-25 supports...
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What causes cylinder liner-wear down?
Explain the difference between “stress and strain”?
I am a mechanical student.And have cleared the written for NTPC. Please suggest what and how to prepare for the interview.i have got only 2-3 weeks in hand.
Will a steel cable become longer if it is heated while under load? Explain
What is extrued aluminum?
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
How to check the round duct measurement
I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?
What are the items to inspect after cylinder liner is pulled out
Inspection for intermediate shaft bearing.
Name of the tables which is going to join two tables in querry ?
What is a positive displacement pump?
Explain why re-heater is used in gas turbine
How do you detect earth by lam p?
What are the properties of fuel oil?
