Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vinod rana
1 . bank of capacitor used
2. induction motor use
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
How to Calculate The sag of OPGW in Transmission Line???
Define gain margin?
Please send 110 kv sb station full single line drawing(sld)
How is the speed of a DC shunt motor related to the armature current?
What are the three major categories of error?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
why did youi choose this career?
