what is the name of software for designing of R.C.C.structures
- 10 Answers
- 14179 Views
- I also Faced
- E-Mail Answers
Answer Posted / ayan sarkar
Stadd Pro... not autocad
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
What are some structures that may be subjected to fatigue?
how to reduce size of column 450 x 750 to 230 x.... if it is cut in area of bathroom? means it appears in bathroon any shifting or any other option....building is g + 10 and the bathroom is at first floor...
What is the likely strength of a 1:2:4 concrete mix?
give me the rate analysis for Bituminous Macadam and SDBC
how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6
can you provide a link for manual design of building?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
What is a projection line?
How to estimate the shuttering material requirement for a slab and beam and shear wall..? Please send thumbrule to estimate material required ( Plywood, Ms plates, runners, acrospans, jacks)
Which is the best book for building construction?
What is the purpose of the gap in the road on this bridge?
how much cement sand n bricks required in im3?and how much in plaster?
silt%= silt volume/ silt+sand volume is this right?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
Pile height is 4.3m. 2nos. under reammer. bulb nose is 75mm and height is 400mm. pile dia is 375mm and overall dia 940mm.pls. help to calculate concrete in pile and bulbs separately. What is formula for bulb volume calculation ?
