Interested to Buy Any Domain ? << Click Here >> for more details...
In one village i have seen Earthing transformer's earthing
line was also connected to the Transformer body to ground
the transformer,can it be possible to maintain 0Volt
reutral line this way?
- 2 Answers
- 5329 Views
- I also Faced
- E-Mail Answers
Answer Posted / ansarelectrapower
distribution transformers are mainly used
delta/star .HTside is delta
LTside is star because star point is earthed.mainly two
conductors are connected through the transformer
neutral .that is body earth and one conductor coming
directly from earth pit.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
testing of Vector Group – YNaoD II
Is there any specialised book to refer about fault level calculation both in MV and LV side??
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
WHAT IS THE DIFFERENCE BETWEEN AN ACB & mccb 7 WHAT IS THE CRITERIA WHEN TO USE WHICH OF THE TWO
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
why in the three pin plug all 3 pins are cutted ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
what is circuit recombiner and how it is different from circuit breaker
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
single phase power supply give to separate one steel coup with water, what reaction create
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
How to set the relay,,??
