we can stepdown the voltage from 230/12v ,and we use the
voltage for various electronics components why can't we
step up the voltage from 12/230v if we can shall we use the
voltage for domestic single phase supply
Answer Posted / uday
Yes, u r correct mr. Kawade, but transmission will too
complecated, coz as voltage is low then resistance will be
high.
Uday
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how open delta PT works & what is its construction?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
Explain mechanical rotational system?
66kv under ground cable how to layaing in ground any special case two ckt r runing
We have two parts in generator, electrical & mechanical. how it works?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
how much allowable resistance that can be difference in motor all coils?
what is kondo syatem in eletrical traction
What is Bolted fault?