what are the protection equipments used betbeen HT line and
transformer in a power plant
Answer Posted / prasad
In between the HT line and transformer there is circuit
breaker which trips on faults. This breaker is controlled
by control realy pannel which does this fuction by taking
inputs from CT and PT signal which are in between this
breaker and transformer.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what is load vs Torque curve & why it is used?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
ratings of lightning arrester
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
what about SAP/MRP regarding manufacturing of electric motors and all drives?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What is CVT and what is relation with wave trap?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
What is the abbreviation of NGT panel
What is the efficiency during maximum power transfer?
what is the importance of Partial Dischage test for Electrical Equipments