Interested to Buy Any Domain ? << Click Here >> for more details...
how much kn lightning arrestor is used in 11kv line
- 8 Answers
- 15412 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / gopal manda
dear ansulji dont angry,u r right,lightning arester is also
use in 11kv network,it placed in various places,it placed
at the top of double pole stracture which is comming b/w
feeder line,gss, arestor is also use in SFU(switch fuse
unit) and it aslo used in single phase transformer,which is
used for rural power distribution,lightning arrestor is use
to ground the lightning phenomena voltage which range is
1000kv and above
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define maximum demand?
List advantges of active filter over passive filter?
design of IGBT firing circuit for 11KV
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
Which type of motor is used in trains, what is the rating of supply used explain working principal?
how to do the ductor test?
What is distance between electrical panel to land ?
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
Why do we perform an open-circuit test and short-circuit test on the transformer?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
How Self works in DG set
