Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tippesh
The main function of fuse is to avoid the fault current or
short circuit current enter through the healthy circuit.
This is used to isolate the entire circuit from fault one
| Is This Answer Correct ? | 38 Yes | 4 No |
Post New Answer View All Answers
Difference between megger test equipment and contact resistance meter test instruments?
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
why does make gain margin and phase margin on same plot.?
why current is constant on d.c?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
What is nyquist contour?
how to calculate the distance relay faulty zone?pls explain?
How to decide whether A / B / C / D curve type MCB should be used?
why swinburnes test cannot be performed on series machines?explain
Where voltage are high and current to be interrupted is low the breaker preferred is:
what are the factors to be considered while design the breaker either HT or LT??
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
can any tell me why slope 40% and 80% is calculated in differential protection?
