Answer Posted / yuvaraj
Relay is only cut off the unit when flow of current more
than it's range set by electromagnetic contact.
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Explain about 3 phase motor fault current calculation with examples?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
What is the difference between cylindrical-type and sandwich-type winding?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What are the conditions for sustained oscillator or what is backhouse criterion?
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
how to calculate mf when meter and cTPT detail are given
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
how slip power recovery system work
Draw torque - speed curve and load curve of induction motor? mark operating point ?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
Explain Continuous and Discrete signals?