Answer Posted / karan
the thumb rule is,I= H.P*1.5
but current depend on Power factor,
Example power factor is 0.85
1 H.p=750kw=Root3*V*I*cosQ=1.73*415*I*0.85
so I=750/1.73*415*0.85=1.23 Amp
when pf is 0.80 then I=1.30
when pf is 0.95 then I=1.09
Is This Answer Correct ? | 17 Yes | 7 No |
Post New Answer View All Answers
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
How many gap between finger contact in a.c.b. and v.cb.?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
How many sprinklers should be in one pipe line?
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
State the factors, for the choice of electrical system for an aero turbine.
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
a starter used for squirrel cage induction motor?
are there rmu for 3 transformer?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
explain wiring system
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me