what are the protection equipments used betbeen HT line and
transformer in a power plant
- 4 Answers
- 7784 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak gupta
can u draw symbol diagram
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
Why saturation region slowly shifted in the left side?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What is current & voltage ? Voltage perform at any load without current or not?
What are different types of control systems?
if sf6 gas low in gis what will happen
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
State kirchoff voltage law?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
