what is different between multiplexer and demultiplexer?
- 12 Answers
- 123497 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashok
I agree with Priyadarshi sahu.But here one thing do u
remember.actually in telecommunications,ISP we use both the
mux and demux .
Mux means --we give many inputs and get single input only
Demux-------we give single input and get more outputs.
ex:consider one Internet service provider(ISP) location
Here in POP(Point of Presence)all are using MUX and Demux
because lot of customers are connected and at customer side
also they connected lot of systems and the data flow b/w all
the systems as well as pop
| Is This Answer Correct ? | 41 Yes | 12 No |
Post New Answer View All Answers
if a PTC having operating voltage 230V is not available then Can we short the circuit where PTC inserted or anybody having other solution. if yes, please reply hurry.
im an electronics and communication engineering..i have to attend an interview based on contract basis.i kindly request u to send all possible questions to my mail. MY EMAIL ID IS -ashishkashyap931@gmail.com
idea uses the 1800mhz band with alloted 4.4mhz bandwidth. this band is divided into 22 channel(up link).how will operator divides these channel in to traffic channel and control channel. explain
What is meant by optical space communication ?
what is a state table?
What are the main purposes for which a cc amplifier may be used.
what is the difference between pre-emphasis and modulation?
Explain why the shape of op-amp is triangular not other shape?
i want to question papers of section engineer post (rrb).please sent my mail id .my id is boobalaraja@ gmail.com
What is a bcd?
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
what were the challenges you faced during the project technically and how did you cope up with that?
What size of a UPS can support a NetGear ProSafe GS752TP Switch (512.8W), up to 4 hours? What size of battery(s) needed & how many?
Please send RRB section engineer's signal paper of past 20 years.This is very urgent.I am giving section engineer exam this syear
What is delay angle?
