Answer Posted / hm
Electric Current is the flow of electrons from higher
potential to lower potential through a conducting medium.
Amount of electron flow depends on potential difference
between them.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
What are the different power system losses and how can it be eliminated?
Which test will be more severe for VCB?
How we can change the direction of rotation of Induction motor? Prove it using graphical
neutral earth resistance testing is it possible for transformer while in load condition
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what is servo motor & how does it work.
why moisture formation found in XLPE Armoured cable outer sheath
what is the function of capacitor duty contactor in an capacitor panel???
State any two nuclear power stations in India, with their generating capacity.
why single CT used in DOL starter power circuit?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
