Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashutosh
Gear hobs are the gear making tool. It is used for cutting and shaping the gear tooth.
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
What is the difference between Maintenance Order and Production Order. the point is i want to know the affection of Movement type 261 thru maintenance order and Production order. if i change any settings for Maintenance order it will affect to production order process also for 261 movement type ?
How to check temperature controller?
Thermo dynamics,Mechanics,Machine design,Design of machine members,dom,tom,strength of materials
What are the dimensionless parameters used in forced convection?
What are the types of cleaning main engine Turbo Charger blower side?
Where id the warm side of a refrigeration system?
Explain the difference between upstream and downstream in a refinery?
Why boiler is purged everytime before starting firing of fuel ?
What is a magnetic valve of refrigeration system?
how to measure static charge in processing of expandable polystyrene. explain - Units of static charge
can i see mahagenco exam model question paper?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What are reasons for poor machinability for IS 2062 steel
how the material no. 2062 will mild steel of desity 7.85? what are the other codes?
Define earth lamp?
