Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the cable size in sq. mm. when the load is
given in KW?
- 3 Answers
- 8995 Views
- I also Faced
- E-Mail Answers
Answer Posted / binay agarwal
For LT motors,
For copper,current carring capacity is 4 times of there
cross section area,
For aluminium,current carring capacity is 3 times of area.
This ratio will continuously decrease as we will go to HT
side motors.
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
Connection diagram for KW meter and Kva meter
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
what is the id1 & id2 setting in differential protection relay of CSPC?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
what is the difference between circular wdg & ractangular wdg?
I need HT sphere gap calibration table. Can any body help me.
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
In dc ckt. 24v or 110v, which one is more efficient and why?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
how to check three phase motor torque value?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
Any one can explaination about calibration with rotating sub standards?
