Answer Posted / dhaval
all electrical parts is two line at one is earthing aa are
joining with earthing all parts outside surface is
insulater..........
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
the winding of Generator and Motor is star or in delta ? and why
what is the necessity of under ground cables ??
Explain how you intend to work under pressure to meet up with deadline target?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What is signal flow graph?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What descriptive information does the NEC require to be marked on all conductors?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
What are the conditions for sustained oscillator or what is backhouse criterion?
What is notching in dc machine?
how to find the capacitance value of the motor while running??
what type of motor used to move a 1 ton gate? and relate ratings with load.