Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sai kumar
The minimum distance between two points is called displacement
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
What is the approximate value of stacking factor?
how many joint can done in HT line and what is life of the joint
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
How to calculate or formula to calculate rhe power in 2 phase system ??
what is the meaning of neutral displacement ???
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
how to decide choke rating for drive?
difference between crane drive and line drive.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
