Interested to Buy Any Domain ? << Click Here >> for more details...
IN bateery size of positive is biger than negative .why?
- 8 Answers
- 12871 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / kumar_3g@yahoo.in
I thnk its just for the standard recognition... like positive is bigger where as negative side is smaller
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Differentiate between voltage and current feedback in amplifiers?
What is slope...? Explain slope 1 and slope 2...?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
What is the magnetic field (coil DC ) of Turbo Expander?
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
66kv under ground cable how to layaing in ground any special case two ckt r runing
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
How to checked frequency drive output voltages?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
define superposition theorem thevnin theorem ,norton theorom?
