Advantages of low voltage drive (control panel)
Answer Posted / guest
1. it is user friendly
2. reduce cast
3. energy saving
4. no external PLC
5. application dedicated feature.
6. smooth power loss ride through
7. adaptive protection
8. easy to use
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
size of condotory fron voltage level
WHaT IS THE CONCEPT OF INDUCTION LAMPS IN MODERN LIGHTINGS, and HOW IT WORKS TO EMIT LIGHT ( AS NO ELECTRODES ARE PRESENT ) ?" COULD INDUCTION LAMPS CAUSE INTERFERENCE WITH COMUNICATIONS INTO A STORE USING INDUCTION LIGHTING ? WHAT IS THE BENEFIT OF USING THE LOW FREQENCY INDUCTION LAMP , VERSUS LED , AND VERSUS FLUORESCENT, AND VERSUS ANOTHER KIND OF LIGHTING . THANK yOU MOISES GUINDI
how to check regenerative load in drived motor
what is th basic difference between a d latch time line and a d flip flop time line???
AL=0B9H,bl=75H, ADD AL,BL AL=____________? CF________? OF___________?
What is meant by rotor?
how to calculate vfd o/p voltage by frequency
What is difference between YNyn0 and YNyn ??
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
what is the differencce inn series and cascade connection??
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.