Interested to Buy Any Domain ? << Click Here >> for more details...
can we change the range of 3151 model level transmitter of
rosemount make? present calibration range is 1000mmwc and
want to change it to 2000mmwc
- 4 Answers
- 8143 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramana
If the Tx. Range is 2000 mmWC we can change it. But we need
little calculation. There is one formula
square root of(P1/P2)= Q1/Q2
Where P1= Pressure 1
P2= Pressure 2
Q1= Flow at Pressure 1
Q2= Flow at Pressure 2
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
give eg of how I/P is used in control loops
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
what is the procedure of belt scale calibration?
What is eddy current? Describe the operating principle of proximity probe.
what is the reset offset and control system in instrumentation
Conversions
Calibration of controller (pneumatic)
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
How to change dcs card in online. (Dsc is maxdna)
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is the difference between PLC and DDC?
selection of the zener barrier for the hazardeous area zone 0
