Interested to Buy Any Domain ? << Click Here >> for more details...
What is percent age of scrap of wires as per IE Rule Clause
No in wiring for House and Industrial wiring ?
- 3 Answers
- 5155 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil guru
9%
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
role of europe union in UK safety legistlation (electrical safety)
What is diversity factor in electric installations?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
what is per unit calculation?looking for simple and strong explanation thk u
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
what causes contact chatter when there is no demand on the air conditioning unit?
How to calculate earth wire load by formula
What is difference between Over Current & Earth Fault protection?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What is the basic principle of welding process?
What is the minimum underground tank size capacity considered for firefighting purpose?
How to calculate mf when meter equipment and meter are connected
Air refrigeration cycle works on the
