Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / a v prasad
CURRENT: rate of flow of charge in a conductor dq/dt
VOLTAGE: work done to move a unit charge . dw/dq
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is difference between slip rings and carbon burushes?
How do we calculate over and under frequency tolerance from generator data?
What technology is used in latest generators?
What is the height of DA, DAL, DB, DC & DDE tower?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
how does a liquid starter reduce the starting currents?
Differentiate between voltage and current feedback in amplifiers?
What are the uses of lead compensator?
What is the vector group of a transformer,how can it be found out?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
