Interested to Buy Any Domain ? << Click Here >> for more details...
WHICH IS BEST INSTRUMENTATION OR ELECTRICAL ENGG?
- 3 Answers
- 7141 Views
- SAS, I also Faced
- E-Mail Answers
Answer Posted / mohammed yousuf
Perhaps Instrumentation engineering since its main objective
is to control the parameters apart from electrical and
sometimes, Instrumentation engg are handy in designing and
monitoring a complete plan which EEE cant do... Also,
Instrumentation are the only streams which connect
mechanical engineering to Computer science engineering for
instrument automation
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
How oil line flow measured?eplain about instruments used and working principle?
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Give Detail information about plc,dcs,and scada system?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
what is the calibration procedure for magnetic flow meter @ onsite
Describe how to use megger to measure the earth resistance and insulation resistance
how to calibrate 0- 150 psi presure gauge by dead weght tester
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
what is difference between HOT permit and cold permit
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Whatis the reset ofset and control system in instrumentation
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
