Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean by vector group? For what purposes we doing
vector group test in transformers?
- 2 Answers
- 6759 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya dev
In the 3 phase AC systems all the phases are having Phase
displacement called electrical Angle.In the case of
transformers the windings are connnected in special Faison
called Vector group. DY11, DYn11 are the vector gruops
which are generally used in India.Testing of vector group
is only to test the electrical of Connected Phases in the
Transformers.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how to find impedance , mutual indatnce in transmission lines
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
Can any body tell gulf interview question for experienced electrical engineer ?
Define active and passive network?
I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
determine two methods to find loose connection in operational electrical system?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
What is tranformer differtial?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
What are safety device in vcb and acb?
Differentiate between real and apparent power?
