what is the difference between power and distribution
transformer?
- 32 Answers
- 60470 Views
- L&T, VJTI, Wenke Electricals, I also Faced
- E-Mail Answers
Answer Posted / manish mathuriya
above 200 kVA power T/F
below 200 kVA distribution T/F
greater the power ratting higher the efficiency.
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
What kinds of decision are made about CT from it's Knee point(voltage & current)?
How to calulate Locked rotor amper(LRA) for compressor type motors?
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
How many kw will suply from one db
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
What is domestic transformer? Draw the connection of domestic transformer.
Write the current equation in series RLC circuits.
distribution is maximum done by a)radial b)network c) parallel d)b & c
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
