Interested to Buy Any Domain ? << Click Here >> for more details...
what is ceiling voltage in an exciter?
- 1 Answers
- 30308 Views
- KEPCO Energy Service Company, I also Faced
- E-Mail Answers
Answer Posted / raghavendran
Consider a Generator operating in three different conditions
when operating at rated load,the AVR applies rated DC
excitation to the field.But consider a condition when there
is a sudden load throw off, the terminal voltage at the
stator will be increased.To compensate for the sudden
increase in voltage level, the DC Exc is reduced
drastically.This is called as 'Negative Ceiling Voltage'.
But when there is a sudden increase in load the terminal
stator voltage drops due to external reaction effect.Hence
the drop in terminal voltage is compensated by sudden
increase in DC Exc.This is called as 'Positive Ceiling
Voltage'.For this the response time of the AVR has to be quick.
The minimum and maximum ceiling voltages may range upto 1.5
times the DC Exc voltage at No-Load and Full Load respectively.
| Is This Answer Correct ? | 48 Yes | 4 No |
Post New Answer View All Answers
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
What happens if we connect a single phase energy meter in reverse polarity.
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
Draw the wave shape of armature current in a generator subjected to a sudden three phase short- circuit at its terminals. Define various reactance of generator from this wave shape.
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
What is the meaning of floating point earthing in battery backed systems ?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
defination of controlled shunt reactor
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What difference between ref protection and differential protection ?
11000volt DG set carnt kaise banvay
what is the ms flat constant for calculating earth mat design calculation?
