Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vasudeva rao
1) power factor is nothing but reactive power control. i.e
if reaactive power requirement is more in the lines then
the angle between active and apparant power changes.
2) other wise simply says cosine angle between voltage and
current
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What are the components of feedback control system?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
What is the difference between vector surge relay (78) and Pole slip relay (98G)
what is meant by motor startup supervision & motor load jam protection ?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
What is speed mode?
I need bhel electrical test pattern & paper
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
Difference between megger test equipment and contact resistance meter test instruments?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Connection diagram for KW meter and Kva meter
Define end float in a motor?
