Interested to Buy Any Domain ? << Click Here >> for more details...
plz tell.. how can we find weight(in kg) of 1 cum of m20
mix..? how can we find the ratio of cement sand and
agregate on site i.e if we given some amount of m20 mix
then hw we find the ratio..?
- 7 Answers
- 58277 Views
- I also Faced
- E-Mail Answers
Answer Posted / syed zafar
M20 means
The mix ratio will be = 1:2:4
That is Cement : Sand : Aggregate
To find out the weight
Add there all = 1+2+4 = 7
1.54 is the design constant
Then for cement (1/7)*1.54 = 0.22m3
One bag (50KG) of cement = 0.0332 m3
Therefore cement required in kg = 332 KG/m3
For sand = (2/7)*1.54 = .44
i.e. = 2*332 = 663 Kgs /m3
For Aggregate = (4/7)*1.54 = .88
i.e. = 2*663 = 1326 Kgs /m3
water cement ratio = 0.42*332 = 140 Kgs
Therefore the weight of one cubic meter of -
Concrete for M20 mix (1:2:4) = 2461 kgs
After exact & all calculations it will come = 2500 kg/m3
| Is This Answer Correct ? | 46 Yes | 45 No |
Post New Answer View All Answers
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
How much for the BRC lapping in full yield and half yield < and which table to get it ?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
What in bending moment, if a moment is free end of cantilever beam?
What is the difference between routing maintenance and major maintenance in school facilities?
What happens when water mixed with cowdung is used for priming instead of water for lifting water in pumps?
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
What are the important hardware systems used for cad?
load combinations how many types for staad design purpose?
What do you mean by bond? What are the different types of bonds?
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
how to identify the failure of building by expansive soils
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
rate analysis hiring of generator 62.5 KVA
Moisture content calculation for diff mix ratio's ??
