Why AC loads wont used in DC input supply?
and
Why DC loads wont used in AC input supply?

Answer Posted / sachin

If we provided DC supply to AC Load it wont work can burn
the load.

and DC volt if provided to AC Load will burn the load.

Is This Answer Correct ?    3 Yes 12 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

What is slope...? Explain slope 1 and slope 2...?

1075


Power Factor Correction Panel (Manual & Automatic)

1685


Define the term Capacitance and Inductance?

647


Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?

2636


we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan

1221






specific difference of ICT&Auto Transformer

1377


difine electrical ballast in HPSVL

1559


what is the difference between RMS & TRUE RMS VOLTAGE

2402


in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

2158


if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?

1003


what is the major difference between LIBBP & HIBBP.. which one is most preferable..

2018


why burdens of VTs is more than CTs?

1342


WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.

1624


Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????

2305


sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai

2907