Interested to Buy Any Domain ? << Click Here >> for more details...
What is OLTC in a transformer, specify its fuction.
- 35 Answers
- 142271 Views
- Bhel, Isgec, L&T, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar behera
OLTC means ONLOAD TAP CHANGER UT CAN BE OPERATED MANUALLY
OR AUTOMETICALLY. TO OPERATE IT IN MANUAL MODE THERE HAVE
CERATIN CONNECTIONS THAT WE HAVE TO GIVE THAT WILL VARY
DEPENDS UPON THE OLTC MAKE WHILE WE WANT TO OPERATE IT IN
AUTOMETIC MODE WE HAVE TO CONNECT IT TO A RTCC PANEL THAT
IS REMOTE TAP CHANGER CIRCUIT.
THE FUNCTION OF OLTC IS TO CHANGE THE TAPS OF A
TRANSFORMER .THAT IS IT ARRANGE CONSTANT OUTPUT ON L.V.
SIDE.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
Graphs of measuring power and speed on dc motor
If rotor works in clock wise what happens
distribution is maximum done by a)radial b)network c) parallel d)b & c
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
Starting current of a 10 HP induction Motor is ______ time’s full load current.
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
What is meant by Load Encroachment in OHL Feeder Protection?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
how many types control panel of a 132/33 kv substation
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
