Interested to Buy Any Domain ? << Click Here >> for more details...
Why TAP changer provided in primary side of HT
transformer ? and why not in secondary?
- 9 Answers
- 49032 Views
- ABB, Reliance, I also Faced
- E-Mail Answers
Answer Posted / ram sumer
This depends on your use,for which perpose transformer is
been used. If the transformer is usde for long distance
transmission line i mean in delta to delta HT transformer
tap changer will be provided on primary side. To cover the
line losses which make a cause of voltage drop,when primary
side tap is changed in ratio of that tap position secondary
will also increase or decrease the voltage as you desire.If
you provide it on secondary side it will oppose the primary
voltage
But in case of distibution transformer i mean delta to star
tap changer is provided at secondary side.
| Is This Answer Correct ? | 4 Yes | 14 No |
Post New Answer View All Answers
how to check regenerative load in drived motor
Installation method of self treated earth electrode.
in what type of applications v can use q meter?
difference between power surge and switching transient
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
What is difference between Over Current & Earth Fault protection?
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
What are the functions of different probes used in cro?
what rectifiers is and what are the types of rectifiers?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.
