voltage at generation stage is usually- ?
a.11kv b.33kv c.66kv d.220kv
- 12 Answers
- 18349 Views
- I also Faced
- E-Mail Answers
Answer Posted / azarudeen
Generation voltage varies depends on capacity of the generator..
For 210 MW Gen - 15.75 KV
600 MW Gen - 20 KV...
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
can u describe the method used for protection of transmission line.
How to calculate the sag of OPGW during stringing???
what is plunger and what's the use of it in motor alignment?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
What are PLC leader logic program method
nwhat are the main Components of servo motor?
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
What are the difference between normal application Transformer and Solar application Transformer?
Control wiring of a dol starter for forward and backward
What is DC series motor?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
