A resistor,inductor and capacitor are connected in series
respectively.Voltage across resistor is 40v,across inductor is
70v,across capacitor is 100v.Then what is the total voltage
applied across the elements?
Answer Posted / weweq
Good Ravi...
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
How to reduce -234126219.6403 MVAr generation and by what?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
i've iocl interview.. if you know the interview process please give me information..
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
Please elaborate th´evenin’s theorem?
block diagram of 2 ups system connected in parallel mode?
Why do we perform an open-circuit test and short-circuit test on the transformer?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
oil cooled transformer
how are reversing the direction of dc motor