Interested to Buy Any Domain ? << Click Here >> for more details...
what is VFD and how to save the power by using VFD?
- 7 Answers
- 10467 Views
- I also Faced
- E-Mail Answers
Answer Posted / virendra
Frequency decrese then flux increase & hence current decrese
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how maney type tempereture measurement ?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
How will change the frequency in distribution side?
Percentage losses in power generation?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
wat system call?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
How can I known multiplying factor .without multiplying table
