suppose we using 3 phase motor of 440 v means what range
of C.T. is require for measuring current ?
Answer Posted / virendra
Rating of CT means maximum carrtent to be measure for that
voltage , powerfactor & Wattage capacity is required.
depending upon that you can calculate the total current to
be measured & also the rating of the current transformer
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how will calculate the safe starting current of 3-phase squirrel cage induction motor?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
what is the ground fault relay,which purpose it will be use,clearly tell me plz
how to calculate earth fault relay current and CBCT ratio
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is meant by brushed alternator & its working principle ?
What are the main advantages of bode plot?
Q: How to calculate Transformer losses , tell us by Formula.
Why neutral cable carry current.
please send me previous year questions of jspl through which i could prepare myself for the test.
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
What is trip and closing coil in cb? Why need of them
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in