Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between AC Drives and DC Drives?
- 14 Answers
- 95444 Views
- College School Exams Tests, La-Gajjar Machineries, LG, Schneider, SMEL, I also Faced
- E-Mail Answers
Answer Posted / hari
1)yes,
2)no,3)yes
| Is This Answer Correct ? | 9 Yes | 19 No |
Post New Answer View All Answers
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
In which working principal temperature transmitter work.explain in detailed.
33kv substation lay out details & line to line & line to earth measurements
when elecromagnatic waves are propogated in a wave guide?
what is is the potential diffrence between two phase ?
what is the difference between elcb and rccb ?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
What is the maximum percentage voltage drop (vd%)for a motor control center
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
what is your aim
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What is difference between Sample test and Routine test in safety standard?
