why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 58230 Views
- I also Faced
- E-Mail Answers
Answer Posted / john zachariah
it depends on the amount...small amount of AC can kill
you...but to be dead with DC u need more amount..cause
AC=1.414Dc
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Why a tesa lamp is glow between two phase?
What is the selection process of breakers. Can any one please give a formulation on same?
What is the formula to find out two phase active & reactive power
What is the method of estamating of cable, CB,MCB ?
what is solkor relay and which condition it will act?
Draw a block diagramof Three UPS systems connected in Parallel mode?
Type of motor stater detail and working detail
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
Zone of protection and tripping scheme of arc protection relay.
What are the necessary components of the feedback control system?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
what are factors to be consider in electrical installation like load factor,diversity factor .....
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
