Interested to Buy Any Domain ? << Click Here >> for more details...
which type of A.C motor is used in the fan (ceiling fan,
exhaust fan, padestal fan, bracket fan etc) which are find
in the houses ?
- 25 Answers
- 73951 Views
- Airtel, MPPTCL, USSA, I also Faced
- E-Mail Answers
Answer Posted / gopal
ceiling fan: 1-phase capacitor start motor
exhaust fan: universal motor
| Is This Answer Correct ? | 32 Yes | 12 No |
Post New Answer View All Answers
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
why induction motors are rated at 0.8 power factor.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
determine two methods to find loose connection in operational electrical system?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
how can i find cable size from current rating?
What happens if i apply 500V to 440V rotary Switch ?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is time response of the control system?
