Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when a electric bulb is connected between
two phases.it will glow or not
- 18 Answers
- 44156 Views
- I also Faced
- E-Mail Answers
Answer Posted / asad durez
If we connect a bulb between two opposite phases for
example (red,yellow)(red,blue)etc.then minimum conect 200
watt lamp because of potential is to high with comapare to
single phase.
+92-334-9107748
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
how we calculate the short circuit capacity of the busbar in LV & HT?
how to calculate mf when meter and cTPT detail are given
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what is the difference between delta delta and star delta connection transformer? why we use delta delta transformer since it need earthing transformer for grounding?
What is the lower limit of break-down voltage of converter transformer.
What are the advantages and disadvantages of the ac motors?
Why are the laminations insulated from each other?
What are the causes for the failures of sandwich type (Al) busducts?
