Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gnb
It's advance version of Redundant.
Redundant: If one processor having one backup processor and
primary fils then secondary will take action and control
the process.
Fault tolerant: Here two processors available and two will
be active but one will be the master and backup will be
slave processor. Here we can avoid the switching time.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Explain working principle of lvdt?
how to turbine speed measurement?
what is IEC code in cables & how to selecting cables?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
defination of radial vibration?
Give 2 application of quartz crystal used for process parameter measurement.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
why we are not using the turbine flow meter in the steam service?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
